Broadcast Tools DSC-20 Manuel d'installation télécharger pdf (Page 11)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

If everything went well, it should look like this:

Right:

See how the end of the insulation sits snug inside the RJ-45, and how the wires go all the

way to the end?

Below are two examples how it should NOT look. In the example on the left the wires

were left too long, which leaves wires unprotected between the RJ-45 and the insulation.

In the example on the right, the wires were cut too short and now don't reach far enough

to make contact.

Wrong!

Double-check one last time that the wires are aligned correctly and all the way in. Then

insert the RJ-45 connector into the appropriate opening of the crimping tool. Give the

handle a nice, tight squeeze without crushing the RJ-45. If you have purchased a pair of

ratchet type crimpers you will know that you are done when they release. If you bought a

cheap-o pair, check to make sure that all of the little metal contacts are even and at the

same height below the plastic of the plug.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 56 57

Pas de commentaire

Broadcast Tools DSC-20 Manuel d'installation Page 11